Clippard Parts partII

Spine · Post by **Spine** » Thu Dec 07, 2006 2:31 pm

Hey,
Just letting everyone know I'm going to call Chocrane Co. with a new Clippard order. I would like to order this Friday afternoon or Monday at the latest, if someone needs more time. It should be here a week after I order. I'm also going to just have them ship it to my house. I am located in Silver Spring,MD. Email me or PM if you need anything.

Kevin

Post by **krisw** » Thu Dec 07, 2006 2:42 pm

Hey Kevin,

Do you have down what I need?

2 MAR-1P-3 0-30 psi low pressure regulators.
2 of the 10/32 -> 1/8 adaptors. (Should be male on 10/32 end, female on 1/8" end. Maybe this #15036-BLK??)

Thanks!
-Kris

Spine · Post by **Spine** » Thu Dec 07, 2006 3:50 pm

Kris,Cristy and Aarron,
I still have your lists .

Kevin

Post by **krisw** » Thu Dec 07, 2006 4:01 pm

Thanks Kevin! If you need me to forward you any of the money before you order, just let me know.

Aaron · Post by **Aaron** » Thu Dec 07, 2006 4:57 pm

Kevin,

I had some other expenses come up. I'm going to have to put a hold on my order for a while. Thanks for putting this together though.

fredyk · Post by **fredyk** » Fri Dec 08, 2006 10:34 am

Hi Kevin,
I ordered a mini-solenoid. Perhaps it could be shipped to your address? don't know if this will just confuse things or if it'll be easier.
Mark

Cristy Keister · Post by **Cristy Keister** » Fri Dec 08, 2006 1:01 pm

I just need the following:

2 MAR-1P-3 0-30 psi low pressure regulators
1 11755-PKG screw plugs-10pkg
1 15002-4-BLK Miniature 3-way manifold

and maybe 2 of the couplers we talked about at the meeting - female on both ends.

It doesn't look to me like the bubble counter can be taken off of the needle valve without the same kind of connection to repace it. None of the barbs you gave me will work there. It's one of the larger male screw ends with a tiny barb. Wish I knew what the sizes were called.

Post by **krisw** » Fri Dec 08, 2006 1:15 pm

Cristy, once you disconnect the bubble counter, I think you screw a 1/8" barb to the bottom of the bubble counter, and then you need a hose clamp to screw onto the needle valve. (Same host clamp that is on the top of the bubble counter.) I don't know where to get those though. Anyone?

Jeff120 · Post by **Jeff120** » Tue May 27, 2008 9:52 pm

Did this order ever go through? Im in need of a brass check valve and about 5' of the CO2 proof tubing. I can get this through Rex, just wondering if there was a local source first

DonkeyFish · Post by **DonkeyFish** » Wed May 28, 2008 12:59 am

At the risk of showing my n00b-ness... is there a website so those of us not-so-good at knowing product lines and their names could take a look?

Clippard Parts partII

Clippard Parts partII

Sponsors