ID part please

Cristy Keister · Post by **Cristy Keister** » Wed Jan 14, 2009 1:39 am

I bought this CO2 splitter some time ago and it's missing a hose clamp. Can someone help me find this part on Clippard? I have no clue what it would be called. I searched for 1/8" hose clamp with no luck. Pic below illustrates what I'm missing.

maddog10 · Post by **maddog10** » Wed Jan 14, 2009 6:56 am

Is it built onto the needle valve? Would you just need to get a new valve?

SCMurphy · Post by **SCMurphy** » Wed Jan 14, 2009 9:51 am

Cristy, can you bring the splitter to the meeting?

ingg · Post by **ingg** » Wed Jan 14, 2009 10:09 am

I know what it is I think, just don't know the thread size to connect.

I think you can actually rebuild this part at Home Depot... don't know where to find it in the Clippard catalog, but I'll peruse a bit and see if I stumble on it (it is downloadable, yay!).

Cristy Keister · Post by **Cristy Keister** » Wed Jan 14, 2009 12:44 pm

Thanks for the help, guys! The threaded part (female) measures 3/8".

I will bring it to the meeting.

ID part please

ID part please

Sponsors